Inforce Computing Forums

inforce computing forums to discuss about inforce products

UART Serial Settings?

Questions and discussions related to Inforce 6410Plus

by jzawodn » Mon Feb 06, 2017 8:31 pm

I'm trying to watch the console as my board boots but I haven't found documentation anywhere that describes the settings one should use when hooking up to the serial/UART headers on the board.

I've tried all the "common" settings for baud rates 8N1 at 9600, 38400, 57600, 119200, etc. And I seem to *always* get garbage on the other end. I've tried going thru 2 different FTDI cables.

Can anyone offer some suggestions on a working setup for doing this?

Thanks,

Jeremy
jzawodn
 
Posts: 2
Joined: Mon Jan 30, 2017 8:19 pm

by Sundeep » Mon Jun 19, 2017 2:12 am

Hello,
The standard baud rate for IFC6410P RS232 header is 115200.
Also please ensure that you are using an RS232 cable only as 3v3 ttl FTDI cables will not work with these boards.

Cheers,
Sundeep
Sundeep
 
Posts: 23
Joined: Wed Jul 01, 2015 9:10 pm


Return to INFORCE 6410PLUS™

Contact Us.